大家好，我现在的项目中主要有采集传感器数据，防丢，和拍照功能。我现在用的是 SIMPLEPROFILE_SERV_UUID（读取从机数据用 SIMPLEPROFILE_CHAR1 ~ SIMPLEPROFILE_CHAR6）和 GAP_APPEARE_GENERIC_HID（控制手机）两个UUID，那么这两个UUID在广播数据中这样写对吗？
static uint8 advertData[] =
{
// Flags; this sets the device to use limited discoverable
// mode (advertises for 30 seconds at a time) instead of general
// discoverable mode (advertises indefinitely)
0x02, // length of this data
GAP_ADTYPE_FLAGS,
DEFAULT_DISCOVERABLE_MODE | GAP_ADTYPE_FLAGS_BREDR_NOT_SUPPORTED,
// service UUID, to notify central devices what services are included
// in this peripheral
0x03, // length of this data
GAP_ADTYPE_16BIT_MORE, // some of the UUID's, but not all
LO_UINT16( SIMPLEPROFILE_SERV_UUID ),
HI_UINT16( SIMPLEPROFILE_SERV_UUID ),
// appearance
0x03, // length of this data
GAP_ADTYPE_APPEARANCE,
LO_UINT16(GAP_APPEARE_GENERIC_HID),
HI_UINT16(GAP_APPEARE_GENERIC_HID),
// service UUIDs
0x05, // length of this data
GAP_ADTYPE_16BIT_MORE,
LO_UINT16(HID_SERV_UUID),
HI_UINT16(HID_SERV_UUID),
LO_UINT16(BATT_SERV_UUID),
HI_UINT16(BATT_SERV_UUID)
};
另外在初始化中配置有什么需要注意的吗？ 我现在用单独的拍照工程可以，把上面两个综合到一起去就不行了，只能配对不能连接了。